Drilling Support - Siemens SINUMERIK 840D Programming Manual

12.97
08.99
1
Example
The following DIN code is
created from the following
input screenform for a 2-
straight-line contour
definition:
X=AC(20) ANG=87.3 RND=2.5 F2000 S500 M3
X=IC(10) Y=IC(-20)

Drilling support

The drilling support includes a selection of drilling
cycles and drilling patterns.
Center
drilling
Deep hole
drilling
Drilling out
Thread
holing
Selection of drilling patterns
Drilling
pattern pos.
Modal
deselection
Drilling patterns may be repeated if, for example, drilling
and tapping are to be executed in succession. Thus, a
name is assigned to the drilling pattern which will later
be entered in the screenform "Repeat position".
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
1.5 Cycle support in the program editor (SW 5.1 and later)
General
08.99
1
1-43