Thread Undercut - Cycle96 - Siemens SINUMERIK 840D Programming Manual

Hide thumbs Also See for SINUMERIK 840D:

Table of Contents

Thread undercut – CYCLE96

CYCLE96 (DIATH, SPL, FORM)

This cycle is for machining thread undercuts in

accordance with DIN 76 on parts with a metric ISO

SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition

Nominal diameter of the thread

Starting point on the contour of the longitudinal axis

Definition of the form

Values: A (for Form A)

B (for Form B)

C (for Form C)

D (for Form D)

4.6 Thread undercut – CYCLE96

Turning Cycles

Show Quick Links

Table of Contents