Thread Chaining - Cycle98 - Siemens SINUMERIK 840D Programming Manual

03.96
4
4.8 Thread chaining – CYCLE98
Programming
CYCLE98 (PO1, DM1, PO2, DM2, PO3, DM3, PO4, DM4, APP, ROP, TDEP, FAL,
IANG, NSP, NRC, NID, PP1, PP2, PP3, VARI, NUMT)
Parameters
PO1
real
DM1
real
PO2
real
DM2
real
PO3
real
DM3
real
PO4
real
DM4
real
APP
real
ROP
real
TDEP
real
FAL
real
IANG
real
NSP
real
NRC
int
NID
int
PP1
real
PP2
real
PP3
real
VARI
int
NUMT
int
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
Starting point of the thread in the longitudinal axis
Diameter of the thread at the starting point
First intermediate point in the longitudinal axis
Diameter at the first intermediate point
Second intermediate point
Diameter at the second intermediate point
End point of the thread in the longitudinal axis
Diameter at the end point
Arc-in section (enter without sign)
Arc-out section (enter without sign)
Thread depth (enter without sign)
Final machining allowance (enter without sign)
Infeed angle
Value range "+" (for flank infeed on flank)
"–" (for alternating flank infeed)
Starting point offset for the first thread (enter without sign)
Number of rough cuts (enter without sign)
Number of noncuts (enter without sign)
Thread pitch 1 as value (enter without sign)
Thread pitch 2 as value (enter without sign)
Thread pitch 3 as value (enter without sign)
Definition of the machining type for the thread
Value range 1 ... 4
Number of threads (enter without sign)
4.8 Thread chaining – CYCLE98
Turning Cycles
4
4-251