Deep-Hole Drilling - Cycle83 - Siemens SINUMERIK 840D Programming Manual

03.96
04.00
2
2.1.4 Deep-hole drilling – CYCLE83
Programming
CYCLE83 (RTP, RFP, SDIS, DP, DPR, FDEP, FDPR, DAM, DTB, DTS, FRF, VARI,
_AXN, _MDEP, _VRT, _DTD, _DIS1)
Parameters
RTP
real
RFP
real
SDIS
real
DP
real
DPR
real
FDEP
real
FDPR
real
DAM
real
DTB
real
DTS
real
FRF
real
VARI
int
_AXN
int
_MDEP
real
_VRT
real
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Final drilling depth relative to reference plane (enter without sign)
First drilling depth (absolute)
First drilling depth relative to reference plane (enter without sign)
Degression: (enter without sign)
Values: > 0 degression as value
< 0 degression factor
= 0 no degression
Dwell time at drilling depth (chip breaking)
Values: > 0 in seconds
< 0 in revolutions
Dwell time at starting point and for swarf removal
Values: > 0 in seconds
< 0 in revolutions
Feedrate factor for first drilling depth (enter without sign)
Value range: 0.001 ... 1
Type of machining
Values: 0 chip breaking
1 swarf removal
Tool axis:
Values: 1 = 1st geometry axis
2 = 2nd geometry axis
or else 3rd geometry axis
Minimum drilling depth
Variable retraction distance for chip breaking (VARI=0):
Values: > 0 is retraction distance
0 = setting is 1 mm
Drilling Cycles and Drilling Patterns
2.1 Drilling cycles
2
2-57