General
1
1.4 Cycle support in program editor (SW 4.3 and later)
1.4.9 Integrating user cycles into the MMC 103 simulation function
Explanation
If you wish to simulate user cycles in the MMC 103,
the call line for each cycle must be entered in file
dpcuscyc.com in directory DA\DP.DIR\SIM.DIR. The
call line must be entered there for each cycle.
Programming example
A user cycle named POSITION1 with 3 transfer
parameters is loaded to the control for simulation.
%_N_POSITION1_SPF
;$PATH=/_N_CUS_DIR
PROC POSITION1 (REAL XWERT, REAL YWERT, REAL ZWERT)
...
M17
The following line
PROC POSITION1 (REAL XWERT, REAL YWERT, REAL ZWERT)
must then be entered in file dpcuscyc.com.
1-38
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
12.97
1
05.98
Siemens AG 2000 All rights reserved.