Configuring Tools (Mmc 100 Only) - Siemens SINUMERIK 840D Programming Manual

General
1
1.4 Cycle support in program editor (SW 4.3 and later)

1.4.5 Configuring tools (MMC 100 only)

Explanation
For MMC 100, you also require a conversion tool to
convert the file format from *.bmp to *.pcx.
These tools are located on the delivery diskette
under the path MMC 100\TOOLS.
This enables you to carry out conversion and
compression to produce a loadable file for MMC
100.
The PCX files are converted and subsequently
compressed into an archive file by means of the
tools PCX_CON.EXE and ARJ.EXE. These tool are
contained on the diskette.
The files to be converted must all reside on one
path, multiple paths are not supported.
Conversion routine call:
makepcx.bat
All parameters required have already been stored in
this file.
The conversion produces the files *.b00 and *.b01.
Prior to compression, copy both these files (*.b00
and *.b01), as well as the arj.exe tool into a path and
start the following call:
arj a cst.arj *.*
1-34
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
12.97
1
 Siemens AG 2000 All rights reserved.