Siemens SINUMERIK 840D Programming Manual page 284

Error Messages and Error Handling
5
5.3 Overview of cycle alarms
Alarm number
61003
61009
61010
61011
61012
61101
61102
61103
61104
5-284
Alarm text
"No feedrate
programmed in the
cycle"
"Active tool number
= 0"
"Final machining
allowance too great"
"Scaling not
allowed"
"Scaling in the plane
different"
"Reference plane
incorrectly defined"
"No spindle direction
programmed"
"Number of holes
equals zero"
"Contour violation of the
slots/elongated holes"
Source Explanation, remedy
CYCLE71 The parameter for feedrate has been
CYCLE72 incorrectly set and must be altered.
CYCLE71 No tool (T) is programmed prior to the
CYCLE72 cycle call.
CYCLE72 The final machining allowance on the
base is greater than the total depth and
must be reduced.
CYCLE71 A scale factor is currently active that is
CYCLE72 not permissible for this cycle.
CYCLE76
CYCLE77
CYCLE71 Either different values must be entered
CYCLE72 for the reference plane and the
CYCLE81 retraction plane if they are relative
to values or an absolute value must be
CYCLE90 entered for the depth
CYCLE840
SLOT1
SLOT2
POCKET1 to
POCKET4
LONGHOLE
CYCLE86 Parameter SDIR (or SDR in
CYCLE87 CYCLE840) must be programmed
CYCLE88
CYCLE840
POCKET3
POCKET4
HOLES1 No value has been programmed for the
HOLES2 number of holes
SLOT1 Incorrect parameterization of the milling
SLOT2 pattern in the parameters that define the
LONGHOLE position of the slots/elongated holes in the
cycle and their shape
SINUMERIK 840D/840Di810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
12.98
5
 Siemens AG 2000 All rights reserved.