Retranslation - Siemens SINUMERIK 840D Programming Manual

General 12.97
08.99
1 1
1.5 Cycle support in the program editor (SW 5.1 and later)

Retranslation

The retranslation of program codes serves to change
an existing program with the help of the cycle support.
The cursor is set to the line to be changed and the
"Retranslation" softkey is pressed.
Thus, the corresponding input screenform which
created the program piece is reopened and values may
be modified.
Directly entering modifications in the created DIN code
may result in the fact that retranslation is no longer
possible. Therefore, consistent use of the cycle support
is required and modifications are to be carried out with
the help of retranslation.
Configuring support for user cycles
References: /IAM/, MMC Installation
Instructions
BE1 "Expand the Operator Interface"
n
 Siemens AG 2000 All rights reserved.
1-46
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition