Milling Rectangular Spigots - Cycle76 (Sw 5.3 And Later) - Siemens SINUMERIK 840D Programming Manual

Milling Cycles
3

3.13 Milling rectangular spigots - CYCLE76 (SW 5.3 and later)

3.13 Milling rectangular spigots - CYCLE76 (SW 5.3 and later)
Programming
CYCLE76 (_RTP, _RFP, _SDIS, _DP, _DPR, _LENG, _WID, _CRAD, _PA, _PO, _STA, _MID,
_FAL, _FALD, _FFP1, _FFD, _CDIR, _VARI, _AP1, _AP2)
Parameters
The following input parameters are always required:
_RTP
real
_RFP
real
_SDIS
real
_DP
real
_DPR
real
_LENG
real
_WID
real
_CRAD
real
_PA
real
_PO
real
_STA
real
_MID
real
_FAL
real
_FALD
real
_FFP1
real
_FFD
real
_CDIR
int
_VARI
int
_AP1
real
_AP2
real
3-172
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (to be added to the reference plane, enter without
sign)
Depth (absolute)
Depth relative to the reference plane (enter without sign)
Spigot length, for dimensioning from corner with sign
Spigot width, for dimensioning from corner with sign
Spigot corner radius (enter without sign)
Spigot reference point, abscissa (absolute)
Spigot reference point, ordinate (absolute)
Angle between longitudinal axis and 1st axis of plane
Maximum depth infeed (incremental, enter without sign)
Final machining allowance on edge contour (incremental)
Final machining allowance at the base (incremental, enter without sign)
Feedrate on contour
Feedrate for depth infeed
Milling direction: (enter without sign)
Value: 0...Climb milling
1...Opposed milling
2 With G2 (irrespective of spindle direction)
3...With G3
Type of machining:
Value: 1...Roughing to final machining allowance
2...Finishing (allowance X/Y/Z=0)
Length of blank spigot
Width of blank spigot
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
04.00
3
 Siemens AG 2000 All rights reserved.