Troubleshooting In The Cycles; General Information - Siemens SINUMERIK 840D Programming Manual

Error Messages and Error Handling
5

5.1 General information

5.1 General information
If error conditions are detected in the cycles, an
alarm is output and execution of the cycle is aborted.
The cycles also output messages in the dialog line of
the control. These messages do not interrupt
processing.
For more information on errors and required
responses, as well as messages output in the
control's dialog line, please refer to the section for
the relevant cycle.
5.2

Troubleshooting in the cycles

If error conditions are detected in the cycles, an
alarm is output and processing is aborted.
Alarms with numbers between 61000 and 62999 are
output in the cycles. This range is again subdivided
according to alarm responses and acknowledgment
criteria.
The text displayed with the number provides an
explanation of the cause of the error.
Alarm number
61000 ... 61999
62000 ... 62999
5-282
Acknowledgment criterion
NC_RESET
Acknowledgment key
SINUMERIK 840D/840Di810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
Alarm reaction
Block preprocessing in the NC is aborted
Block preprocessing is interrupted, the
cycle can be continued with NC Start
once the alarm has been acknowledged
 Siemens AG 2000 All rights reserved.
03.96
5