General
1
1.4 Cycle support in program editor (SW 4.3 and later)
1.4.2 Configuring cycle selection
Function
The cycle selection is configured in the cov.com file:
• The cycle selection is assigned directly to
softkeys that are configured in the cov.com file.
• Up to three softkey levels with up to 18 softkeys
are supported; this enables the cycles to be
classified in subsets, e.g. of one technology.
• If a maximum of 6 cycles are configured on one
of the softkey levels, they all lie on a vertical
softkey tree. The 7th and 8th softkeys are
reserved for operator functions such as "Back"
or "Abort" or "Ok".
If the corresponding level contains more than 6
cycles, then the program labels the 7th softkey
with ">>" and switches the vertical softkey over
to the 2nd level.
• Only 4 softkeys are available on the first level, the
first softkey is reserved.
Example for cycle selection
1-28
a
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
12.97
1
Turning
Drilling
Milling
Thread
Siemens AG 2000 All rights reserved.