Control Board Identifier; Drive Current Rating; Core Parameter Database Version - Emerson Unidrive M200 Parameter Reference Manual

Power Stage Identifier (11.066) is used to show power stages that require changes to the drive user parameters (i.e. visibility, range or defaults). It is
anticipated that all power stages will require the same parameter structure, and so Power Stage Identifier (11.066) will always be equal to zero. It should
be noted that this parameter does not identify the rating of the power stage.
Power Stage Identifier (11.066)
0
1
2
Parameter

11.067 Control Board Identifier

Short description Displays the control board identifiers within the drive
Mode Open‑loop
Minimum 0
Default
Type 8 Bit Volatile
Display Format Standard
Coding RO, ND, NC, PT, BU
Control Board Identifier (11.067) identifies the main control board hardware as given in the table below.
Control Board Identifier
(11.067)
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Parameter

11.068 Drive current rating

Short description Drive current rating in 0.1 of Amps
Mode Open‑loop
0
Minimum
(Display: 00000)
Default
Type 16 Bit Volatile
Display Format Lead Zero Pad
Coding RO, ND, NC, PT
See Product Identifier Characters (11.064).
Parameter

11.070 Core Parameter Database Version

Short description Displays the core parameter database version within the drive
Mode Open‑loop
Minimum 0.00
Default
Type 16 Bit Volatile
Display Format Standard
Coding RO, ND, NC, PT
Core Parameter Database Version (11.070) gives the version number of the parameter database used to define the core parameter menus in the drive
(Menu 1 to 14 and 21 to 23) in 2 digit BCD format. All other menus are customisable and if these menus are changed their default values are
automatically loaded. However, if the drive software is changed it may be necessary to load defaults for all menus, although this will only be required
rarely. Defaults for all menus are loaded when the most significant digit of Core Parameter Database Version (11.070) changes. Therefore if the drive
firmware is modified and the most significant digit of the core database version has changed an EEPROM Fail.001 trip is initiated and default
parameters are loaded.
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10
Power stage
Standard M600-M800
Standard M100-M400
Standard ID300,ID302
Control
board
Reserved
Reserved
M100
Reserved
Reserved
M101
Reserved
Reserved
M200
Reserved
Reserved
M201
Reserved
Reserved
M300
Reserved
Reserved
M400
ID300/ID302
Maximum 255
Units
Update Rate Power-up write
Decimal Places 0
32767
Maximum
(Display: 32767)
Units
Update Rate Power-up write
Decimal Places 0
Maximum 99.99
Units
Update Rate Power-up write
Decimal Places 2
185