Emerson Unidrive M200 Parameter Reference Manual page 150

Value Text
185 C.Acc
178 C.by
188 C.cPr
179 C.d.e
183 C.dAt
182 C.Err
184 C.Ful
180 C.OPt
175 C.Pr
181 C.rdo
186 C.rtg
187 C.Typ
28 cL.A1
29 cL.A2
35 CL.bt
231 Cur.c
97 D.Ch
110 dcct
246 Der.E
248 Der.I
199 dESt
232 Dr.Cf
31 EEF
6 Et
173 FaN.f
247 Fi.Ch
237 FI.In
20 It.ac
19 It.br
90 LF.Er
236 no.PS
0 None
26 O.Ld1
7 O.Spd
27 Oh.dc
219 Oht.C
21 Oht.I
22 Oht.P
189 OI.A1
190 OI.A2
3 OI.aC
4 OI.br
228 OI.E1
229 OI.E2
230 OI.E3
92 OI.Sn
98 Out.P
2 OV
220 P.Dat
34 Pad
245 Pb.bt
93 Pb.Er
235 Pb.HF
37 Pd.S
32 PH.Lo
5 PSU
227 r.All
250 R.b.ht
1 Res
9 Res
10 Res
12 Res
14 Res
15 Res
16 Res
150
Description
Communication failure with NV media card detected
NV media card in use
NV media card data and drive data is not the same
NV media card data already exists
Attempt to read non-existant data detected
NV media card data structure error detected
NV media card is full
Option difference detected
Product difference detected
Attempt to overwrite protected data detected
Transfer of data between drives of different ratings detected
Transfer of data between drives operating in different modes
detected
Current loop loss on analog input 1
Current loop loss on analog input 2
Control word trip (bit 12)
Current feedback calibration range error
Drive has become active while data is being updated
DC Current transformer failure (size 5 and above)
Derivative Image error
Derivative program error
A parameter is being changed by more than 1 routing
destination
Incorrect configuration data
Non-volatile memory failure
External trip generated by the application
Cooling fan failure
Configuration data within the drive has changed
The power stage and control board firmware versions are not
compatible
Motor over temperature
Brake resistor over temperature
Communication link failure in the power stage (size 5 and
above)
No power stage detected by the Control board
No trip recorded
Overload on 24V or digital outputs
Motor over speed
Overload on DC bus components
Control board over temperature
Inverter IGBT junction over temperature
Power stage over temperature
Current loop overload on analog input 1
Current loop overload on analog input 2
Over current at the motor terminals
Over current in the brake IGBT
Over current on U phase
Over current on V phase
Over current on W phase
Over current in snubber components (size 5 and above)
One of the motor windings is not drawing current
DC Bus voltage is high
Configuration data failure
Keypad communication failure
Power stage processor is in its boot loader
Communication link failure between Control board and power
stage
Harware Fault in the power stage processor detected
Power down saved parameters have been corrupted
Input Phase Loss
Internal Power Supply fault
RAM allocation failure
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10