Loading Defaults - Emerson Unidrive M200 Parameter Reference Manual

4. Two banks are not provided in non-volatile media cards therefore the card could be corrupted if the power is removed when the drive is writing
data to the card.

Loading defaults

A drive reset with 1233 in Parameter mm.000 (mm.000) loads the defaults defined for each parameter. If defaults are loaded with 1244 in Parameter
mm.000 (mm.000) then the parameters in the table below have different defaults that are intended for the 60Hz regions.
Parameter
Maximum reference clamp (01.006)
Standard Ramp Voltage (02.008)
Motor Rated Frequency (05.006)
Motor Rated Load rpm (05.008)
Motor Rated Voltage (05.009)
M2 Maximum Reference Clamp (21.001)
M2 Motor Rated Frequency (21.006)
M2 Motor Rated Load rpm (21.008)
M2 Motor Rated Voltage (21.009)
Non-volatile media card data transfer
Details of the data that can be stored on a non-volatile media card and the methods to transfer/access this data are given in Menu 11.
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10
Default Drive modes
60.00Hz All
775V All
60.00Hz All
1800rpm All
460V All
60.00Hz All
60.00Hz All
1800rpm All
460V All
Drive voltage rating
All
400V
All
All
400V
All
All
All
All
5