Installing An Expansion Card (Pci & Pci-Express); Configuring An Expansion Card - Viglen Vig410p Manual

Installing an expansion card
To install an expansion card:
1. Before installing the expansion card, read the documentation that came with it and
make the necessary hardware settings for the card.
2. Remove the lid from the system by un-screwing the two screws at the rear of the
case
2. Remove the bracket opposite the slot that you intend to use. Keep the screw for
later use.
3. Align the card connector with the slot and press firmly until the card is completely
seated on the slot.
4. Secure the card to the chassis with the screw you removed earlier.
5. Replace the system lid.

Configuring an expansion card

After installing the expansion card, configure the card by adjusting the software
settings.
1. Turn on the system and change the necessary BIOS settings, if any.
2. Install the software drivers for the expansion card.
PCI Slots
There are two 64-bit PCI slots on this Motherboard. The slots support PCI cards such
as a LAN card, SCSI card, USB card, and other cards that comply with PCI
specifications.
Figure 32: Installing a PCI card
Vig410P Motherboard Manual
43