Viglen Vig410p Manual page 74

Configuring the Adaptec SATA RAID for Operating Systems
that support RAID
1. Press the <Del> key during system bootup to enter the BIOS Setup Utility.
Note: If it is the first time powering on the system, we recommend you load the
Optimized Default Settings. If you have already done so, please skip to Step 3.
2. Use the arrow keys to select the "Exit" Settings. Once in the "Exit" settings, Scroll
down to select "Load Optimized Default Settings" and press the <Enter> key. Select
"OK" to confirm the selection. Press the <Enter> key to load the default settings for
the BIOS.
3. Use the arrow keys to select the "IDE/Floppy Configuration" section in BIOS.
4. Scroll down to "SATA#1 Configuration" and press the <Enter> key to select
"Enhanced".
5. Scroll down to "Configure SATA#1 as" and press <Enter>. Then, select "RAID"
6. Scroll down to "ICH RAID CodeBase" and press <Enter>. Then, select "Adaptec"
7. Go to "Exit." Select "Exit Saving Changes" from the "Exit" menu. Press the <Enter>
key to save the changes and exit the BIOS.
8. Once you've exited the BIOS Utility, the system will re-boot.
9. During the system boot-up, press the <Ctrl> and <A> keys simultaneously to run the
Adaptec RAID Configuration Utility when prompted by the following message: Press
<Ctrl> <A> for the Adaptec RAID Configuration Utility.
Note: The Adaptec RAID Configuration Utility is only available for systems with two or
more drives installed. The Adaptec RAID Utility screen will not display in systems with
one drive installed.
Vig410P Motherboard Manual
73