Viglen Vig410p Manual page 82

Table of Contents

Advertisement

2. Under the item "Arrays Label", type in a label and press <Enter>.
Note:
The label shall not be more than 15 characters.
3. For RAID 0, select the desired stripe size.
Note:
Available stripe sizes are 16, 32, and 64 KB. 64K is default. Please do not
change the default setting.
4. The item: "Create RAID via" allows you to select between the different ways of
creating methods for RAID 0 and RAID 1.
The following table gives examples of when each is appropriate.
RAID Level
Create Via
RAID 0
Quick Init
RAID 0
Migrate
RAID 1
RAID 1,
RAID 10
RAID 1,
Quick Init
RAID 10
Note:
If you select Migrate for RAID 0, or Build for RAID 1, you will be asked to select
the source drive. The contents of the source drive will be preserved. However, the data
on the new drive will be lost.
5.
When you are finished, press <Done> (as the screen shown below).
Creating a RAID 0 on new drives
Creating a RAID 0 from one new drive and one drive with
data you wish to preserve
Build
Any time you wish to create a RAID 1, but especially if you
have data on one drive that you wish to preserve
Clear
Creating a RAID 1 or RAID 10 on new drives, or when you
want to ensure that the array contains no data after creation.
Fastest way to create a RAID 1 or RAID 10 Appropriate
when using new drives
Figure 53: Assigning Array Properties
Vig410P Motherboard Manual
When Appropriate.
81

Advertisement

Table of Contents
loading

Table of Contents