Chapter 2: System Board Options - Viglen Vig410p Manual

Chapter 2: System Board Options

 The Vig410P Motherboard is capable of accepting Duo Xeon 5500 (Nehalem)
processors. RAM can be upgraded to a maximum of 24GB using DDR3
Registered ECC or Unbuffered ECC/Non-ECC 1333 MHz/1066 MHz/800 MHz
Memory
WARNING!
Unplug the system before carrying out the procedures described in this
chapter. Failure to disconnect power before you open the system can result in
personal injury or equipment damage. Hazardous voltage, current, and energy
levels are present in this product. Power switch terminals can have hazardous
Voltages present even when the power switch is off.
The procedures assume familiarity with the general terminology associated with
personal computers and with the safety practices and regulatory compliance
required for using and modifying electronic equipment.
Do not operate the system with the cover removed. Always replace the cover
before turning on the system.
As the colours of the wires in the mains lead of this computer may not correspond with the
coloured markings identifying the terminals in your plug precede as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug
which is marked by the letter E or by the safety Earth symbol
and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the
letter L or coloured red.
CAUTION!
The Viglen Vig410P Motherboard
and associated components are
sensitive electronic devices. A small
static shock from your body can
cause expensive damage to your
equipment.
Vig410P Motherboard Manual
or coloured green or green-
19