Viglen Vig410p Manual page 121

4. Power on your system and click the <Connect> button in the Hyper Terminal. The
terminal screen will display the following messages.
5. Following the instructions given on the screen to update the BIOS. These
instructions are also shown below.
A. At the prompt, press the <SpaceBar> to update the BIOS.
B. When asked to confi m BIOS updating, press <y> to confirm BIOS updates.
C. Press <y> again to begin flashing BIOS remotely.
Note:
Be sure to complete Steps A~C above quickly because you have a second or less to
do so.
6. Once you've completed the instructions given, a screen will display to indicate that
remote flashing is starting and the new BIOS file is being uploaded.
7. To use Hyper Terminal to transfer the XModem protocol by using the "Send File"
dialog under the "Transfer" menu, follow the instructions below to complete
XModem transfers.
A. Select the "Transfer" menu and enter <Send>.
Figure 70: Hyper Terminal Screen
Figure 71: XModem transfers
Vig410P Motherboard Manual
120