Viglen Vig410p Manual page 38

3. Remove the heatsink screws from the Motherboard in the sequence as shown in
the picture below.
4. Gently wriggle the heatsink to loosen it from the CPU. (Do not use excessive force
when wriggling the heatsink!!).
5. Once the heatsink is loosened, remove the heatsink from the CPU socket.
6. Clean the surface of the CPU and the heatsink to get rid of the old thermal grease.
Reapply the proper amount of thermal grease on the surface before you re-install
the CPU and the heatsink.
Installing the CPU:
1. Press the socket clip to release the load plate that covers the CPU socket from its
locking position.
2. Gently lift the socket clip to open the load plate.
Figure 20: Heatsink screws
Figure 21: Release load plate
Figure 22: Lift Load Plate
Vig410P Motherboard Manual
37