Chassis Intrusion; Fan Connectors - Viglen Vig410p Manual

 Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the Motherboard. Attach an appropriate
cable from the chassis to inform you of a chassis intrusion when the chassis is opened.
 Fan Connectors
This Motherboard has four chassis/system fan headers (Fan 3 to Fan6) and two CPU
fans (Fan1/Fan2) on the Motherboard. All these 4-pin fans headers are backward
compatible with the traditional 3-pin fans. However, fan speed control is available for 4-
pin fans only. The fan speeds are controlled by Thermal Management via Hardware
Monitoring in the Advanced Setting in the BIOS. (The Default setting is Disabled.) See
the table for pin definitions
CAUTION!!
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow
inside the system may damage the Motherboard components. These are not
jumpers!! Do not place jumper caps on the fan connectors!!
Note: All these fan connectors are 4-pin.
.
Figure 10: Fan connectors
Vig410P Motherboard Manual
A- Fan 1 (CPU2 Fan)
B- Fan 2 (CPU1 Fan)
C- Fan 3
D- Fan 4
E- Fan 5
F- Fan 6
G- Chassis Intrusion
29