Table of Contents
Advertisement
The Intel HostRAID Configurations
The following types of Intel's HostRAID configurations are supported:
RAID 0 (Data Striping): this writes data in parallel, interleaved ("striped") sections of
two hard drives. Data transfer rate is doubled over using a single disk.
RAID1 (Data Mirroring): an identical data image from one drive is copied to another
drive. The second drive must be the same size or larger than the first drive.
RAID 10 (Striping & Mirroring): RAID 0 and 1 schemes are combined (without parity
information) to get the benefits of both.
RAID 5: both data and parity information are striped and mirrored across three or more
hard drives.
The Intel Matrix Storage
The Intel Matrix Storage, supported by the ICH10R, allows the user to create RAID 0,
RAID 1, RAID 10 and RAID 5 sets by using only six identical hard disk drives. The Intel
Matrix Storage Technology creates two partitions on each hard disk drive and
generates a virtual RAID 0, RAID 1, RAID 10 and RAID 5 sets. It also allows you the
change the HDD partition size without any data.
Configuring BIOS settings for SATA RAID Functions (Native Mode)
1. Press the <Del> key during system bootup to enter the BIOS Setup Utility.
Note:
If it is the first time powering on the system, we recommend you load the
Optimized Default Settings. If you have already done so, please skip to Step 3.
2. Use the arrow keys to select the "Exit" Settings. Once in the "Exit" settings, Scroll
down to select "Load Optimized Default Settings" and press the <Enter> key. Select
"OK" to confirm the selection. Press the <Enter> key to load the default settings for
the BIOS.
3. Use the arrow keys to select the "IDE/Floppy Configuration" section in BIOS.
4. Scroll down to "SATA#1 Configuration" and press the <Enter> key to select
"Enhanced".
5. Scroll down to "Configure SATA#1 as" and press <Enter>. Then, select "RAID"
6. Scroll down to "ICH RAID CodeBase" and press <Enter>. Then, select "Intel"
7. Go to "Exit." Select "Exit Saving Changes" from the "Exit" menu. Press the <Enter>
key to save the changes and exit the BIOS.
8. Once you've exited the BIOS Utility, the system will re-boot.
Vig410P Motherboard Manual
63
Advertisement
Table of Contents
