Installing An Expansion Card - Viglen Vig430p Manual

To Remove DIMM:
1. Simultaneously press the retaining clips outward to unlock the DIMM
Note: Support the DIMM lightly with your fingers when pressing the retaining clips. The DIMM
might get damaged when it flips out with extra force.
2. Remove the DIMM from the socket

Installing an expansion card

To install an expansion card:
1. Before installing the expansion card, read the documentation that came with it and make the
necessary hardware settings for the card.
2. Remove the lid from the system by un-screwing the two screws at the rear of the case
2. Remove the bracket opposite the slot that you intend to use. Keep the screw for later use.
3. Align the card connector with the slot and press firmly until the card is completely seated on
the slot.
4. Secure the card to the chassis with the screw you removed earlier.
5. Replace the system lid.
Figure 26: Removing DIMM
Vig430P Motherboard Manual
39