Table of Contents
Advertisement
Watch Dog Enable/Disable Jumper (JWD)
JWD controls the Watch Dog function. Watch Dog is a system monitor that can reboot
the system when a software application is "hung up". The table below describes the
jumper settings.
Table 8: Watch Dog Jumper
Function/Mode Jumper Setting
(Default)
Reset
NMI
Disable
Audio Enable/Disable Jumper (JPAC)
JPAC enables or disables Audio Controller on the Motherboard. The table below
describes the jumper settings.
Table 9: Audio Jumper
Function/Mode Jumper Setting
(Default)
Enable
Disable
2
I
C Bus to PCI Slots Jumper (JI
2
2
Jumpers JI
C1/JI
C2 allows you to connect the System Management Bus (I
slots. The table below describes the jumper settings.
2
Table 10: I
C Bus to PCI slots Jumper
Function/Mode Jumper Setting
Enables
(Default)
Disable
1-2
2-3
Open
1-2
2-3
2
C1/JI
Closed
Open
Vig410P Motherboard Manual
Configuration
This will cause WD to reset the system if an
application is hung up.
This will generate a non-maskable interrupt
signal for the application that is hung up
This disables the Watch Dog feature
Configuration
Enables the onboard audio controller
Disables the onboard audio controller
2
C2)
Configuration
This enables the System Management Bus
2
(I
C) to PCI slots connection.
This disables the System Management Bus
2
(I
C) to PCI slots connection.
2
C) to PCI
23
Advertisement
Table of Contents
