Table of Contents
Advertisement
2.
Select the desired disk and press <Enter>. The following screen appears:
To format a disk:
Note:
The operation of Formatting Disk allows you to perform a low-level formatting of
a hard drive by writing zeros to the entire disk. Serial ATA drives are low-level
formatted at the factory and does not need to be low-level formatted again.
1. When the screen shown below displays, select Format Disk and press <Enter>.
The following screen appears:
2. Read the warning message when it appears in the screen as shown below. To
continue with disk formatting, select Yes and hit <Enter>. Otherwise, select No and
press <Enter>.
CAUTION!!
Formatting a disk destroys all data on the drive. Be sure to back up your data
before formatting a disk.
Figure 60: Formatting Disk
Vig410P Motherboard Manual
89
Advertisement
Table of Contents
