Viglen Vig410p Manual page 41

Table of Contents

Advertisement

Installing Heatsink
1. Do not apply any thermal grease to the heatsink or the CPU die; if it has already
been applied.
If Heatsink thermal paste is not already applied to heatsinks this must
be done now.
2. Place the heatsink on top of the CPU so that the four mounting holes are aligned
with those on the retention mechanism.
3. Screw in two diagonal screws (i.e. the #1 and the #2 screws) until just snug (Do not
fully tighten the screws to avoid possible damage to the CPU.)
4. Finish the installation by fully tightening all four screws.
5. Repeat the steps for the second heatsink if required.
Figure 28: Heatsink diagonal screw locations
Vig410P Motherboard Manual
40

Advertisement

Table of Contents
loading

Table of Contents