Viglen Vig410p Manual page 79

3. The drive you've selected will appear in the "Selected Drives Dialog Box" on the
right (as shown below.) Repeat the same steps until all drives that you want to
configure appear in the selected drives box.
4. Once both drives display in the selected drive box, press <Enter.>
5. Read the warning message as shown in the screen below.
6. Make sure that you have selected the correct disk drives to configure. If correct,
type Y to continue.
Figure 48: List of Selected Drives for Configuration
Figure 49: List of Selected Drives for Configuration
Vig410P Motherboard Manual
78