Advanced Chipset Control - Viglen Vig410p Manual

Advanced Chipset Control

The items included in the Advanced Settings submenu are listed below:
QPI & IMC Configuration
QPI Links Speed
This feature selects QPI's data transfer speed. The options are Slow-mode, and Full
Speed.
QPI Frequency
This selects the desired QPI frequency. The options are Auto, 4.800 GT, 5.866GT,
6.400 GT.
QPI L0s and L1
This enables the QPI power state to low power. L0s and L1 are automatically selected
by the Motherboard. The options are Disabled and Enabled.
Memory Frequency
This feature forces a DDR3 frequency slower than what the system has detected. The
available options are Auto, Force DDR-800, Force DDR-1066, and Force DDR-1333.
Memory Mode
The options are Independent, Channel Mirror, and Lockstep. Independent - All DIMMs
are available to the operating system. Channel Mirror - The Motherboard maintains two
identical copies of all data in memory for redundancy. Lockstep - The Motherboard
uses two areas of memory to run the same set of operations in parallel.
Demand Scrubbing
A memory error-correction scheme where the Processor writes corrected data back
into the memory block from where it was read by the Processor. The options are
Enabled and Disabled.
Patrol Scrubbing
A memory error-correction scheme that works in the background looking for and
correcting resident errors. The options are Enabled and Disabled.
Throttling - Closed Loop / Throttling - Open Loop
Throttling improves reliability and reduces power in the processor by automatic voltage
control during processor idle states. Available options are Disabled and Enabled. If
Enabled, the following items will appear:
Hysteresis Temperature (Closed Loop only)
Temperature Hysteresis is the temperature lag (in degrees Celsius) after the set
DIMM temperature threshold is reached before Closed Loop Throttling begins.
The options are Disabled, 1.5oC, 3.0oC, and 6.0oC.
Vig410P Motherboard Manual
103