Table of Contents
Advertisement
Memory Errors
When a No_Memory_Beep_Code is issued by the system, check the following:
1. Make sure that the DIMM modules are properly and fully installed.
2. Check if different speeds of DIMMs have been installed and check if the BIOS setup
is configured for the fastest speed of RAM used. (It is recommended to use the
same RAM speed for all DIMMs in the system.)
3. Make sure you are using the correct type of DDR3 Registered ECC or Unbuffered
ECC/Non-ECC 1333 MHz/1066 MHz SDRAM (recommended by the manufacturer.)
4. Check for bad DIMM modules or slots by swapping a single module between all
memory slots and check the results.
5. Make sure that all memory modules are fully seated in their slots. Make sure to
follow the instructions given on DIMM population on page 17 Check the position of
the 115V/230V switch on the power supply.
6. Please follow the instructions given in the DIMM Population Tables listed on page
17to install your memory modules.
Vig410P Motherboard Manual
49
Advertisement
Table of Contents
