Modifying Table Rows - AudioCodes Mediant 800B User Manual

3. Click Apply to add the row to the table or click Cancel to ignore your configuration.
4. If the Save
settings to flash memory, otherwise they are discarded if the device resets (without a
save to flash) or powers off.
6.1.6.1.1 Assigning a Row from Another Table
A table may contain parameters assigned a value which is a row referenced from another
table. For example, the 'Proxy Set' parameter in the IP Groups table is used to assign a
Proxy Set (configured in the Proxy Sets table) to an IP Group. For such parameters, a
View button (as shown in the example below) appears next to their fields, which opens the
row-referenced table (e.g., Proxy Sets table).
The View button is useful in that it not only allows you to check the configured rows before
deciding which one to assign the parameter, but also allows you to configure a new row
and then assign it to the parameter. When you click the button, the dialog box in which the
parameter appears (e.g., for the IP Group) is minimized in the bottom-left corner of the
Web interface and the row-referenced table (e.g., Proxy Sets table) opens, as shown in the
example below:
Figure 6-7: Dialog Box Minimized and Referenced Table Opened
To return to your configuration, click the arrow
restore it to its previous size.
6.1.6.2

Modifying Table Rows

The following procedure describes how to modify (edit) the configuration of an existing
table row. Remember that a gray-colored dot
(as shown in the example below), indicates that it was changed from its default value:

To edit a table row:
1. Select the row that you want to edit.
2. Click the Edit
displaying the current configuration settings of the row.
3. Make your changes as desired, and then click Apply; the dialog box closes and your
new settings are applied.
4. If the Save
settings to flash memory, otherwise they are discarded if the device resets (without a
User's Manual
button is surrounded by a red border, you must save your
Figure 6-6: Clicking View Button (Example)
button, located on the table's toolbar; a dialog appears
button is surrounded by a red border, you must save your
56
Mediant 800B Gateway & E-SBC
icon on the minimized dialog box to
icon displayed next to a parameter's value
Document #: LTRT-10298