Figure 3-3: Multiple Interface Table Page; Table 3-2: Default Lan Data-Routing Ip Address - AudioCodes Mediant 800 MSBG Installation Manual

3.2.1.1.1 VoIP and Management LAN Interface
The procedure below describes how to assign an IP address to the LAN VoIP and
Management interface.
Notes:
To assign a LAN VoIP and Management IP address:
1. Open the 'IP Settings' page (Configuration tab > VoIP menu > Network submenu >
IP Settings).
2. Select the 'Index' radio button corresponding to the Application Type "OAMP + Media
+ Control" (i.e., VoIP and management interface), and then click Edit.
3. Configure the new IP address and prefix length so that it corresponds to your network
IP addressing scheme (e.g., 10.8.6.86).
4. Configure additional IP interfaces, if required.
5. Click Apply and then Done to apply and validate settings. If validation fails, the device
does not reboot.
6. Save your settings to flash memory and reset the device (refer to 'Saving Configuration
and Resetting the Device' on page 53).
3.2.1.1.2 Data-Routing LAN Interface
The default IP address of the LAN data-routing interface is listed in the table below:
Parameter
IP Address
Subnet Mask
Default Gateway
Note:
Installation Manual
•
The VoIP and Management interface must be in the same subnet as the
data-routing interface.
•
When operating with VoIP and data-routing functionalities, it is
recommended to define the Default Gateway IP address for the VoIP
network interfaces in the same subnet and with the same VLAN ID as the
IP address defined later for the data-routing LAN interface.

Figure 3-3: Multiple Interface Table Page

Table 3-2: Default LAN Data-Routing IP Address

192.168.0.1
255.255.255.0
0.0.0.0
The LAN data-routing interface must be in the same subnet as the VoIP and
Management interface.
Default Value
38
Mediant 800 MSBG
Document #: LTRT-10205