Control Cabinet Installation; Mounting Instructions; Table 28: Mounting Instructions For Built-In Version; Table 29: Mounting Instructions For Push-Through Version - KEB COMBIVERT F6 Series Instructions For Use Manual

DIMeNSIONS AND WeIGHTS

3.4.6 control cabinet installation

3.4.6.1 Mounting instructions

For mounting the drive controllers, the following mounting materials were tested with the
corresponding quality by KEB.
required material
Hexagon-head screw ISO 4017 - M8 - 8.8
Flat washer ISO 7090 - 8 - 200 HV
Table 28:
required material
Hexagon-head screw ISO 4017 - M6 - 8.8
Flat washer ISO 7090 - 6 - 200 HV
Table 29:
NOTICE
54
Mounting instructions for built-in version
Mounting instructions for push-through version
Use of other mounting material
► The alternatively selected mounting material must comply with the
above-mentioned material characteristics (quality) and tightening
torques !
The use of other mounting materials is beyond KEB's control and is
therefore the sole responsibility of the customer.
Tightening torque
22 Nm
194 lb inch
―
Tightening torque
9 Nm
80 lb inch
―