Product Identification - GE 469 Instruction Manual

CHAPTER 3: INSTALLATION
FIGURE 3–1: Dimensions
To prevent unauthorized removal of the drawout unit, a wire lead seal can be installed in
the slot provided on the handle. With this seal in place, the drawout unit cannot be
removed. A passcode or settings access jumper can be used to prevent entry of settings
but allow monitoring of actual values. If access to the front panel controls must be
restricted, a separate seal can be installed on the cover to prevent it from being opened.
Hazard may result if the product is not used for its intended purpose.
FIGURE 3–2: Seal on Drawout Unit
3.1.2

Product Identification

Each 469 unit and case are equipped with a permanent label. This label is installed on the
left side (when facing the front of the relay) of both unit and case. The case label details
which units can be installed.
The case label details the following information: model number, manufacture date, and
special notes.
3–2 469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL