Timer - GE 469 Instruction Manual

6.5.3 Timers
 TIMERS
6–32
Two of the 469 general counters count the number of motor starts or start attempts and
the number of Emergency Restarts performed to start a given motor over time. This may
be useful information when troubleshooting a motor failure. When either of these counters
exceeds 50000, that counter will reset to 0. This information can be cleared with the
 
SETUP INSTALLATION
General counters will count the number of starter operations performed over time. This
counter is incremented any time the motor is stopped, either by a trip or normal stop. This
may be useful information for starter maintenance. When the counter exceeds 50000, that
counter will reset to 0. This information may be cleared with the

INSTALLATION RESET STARTER INFORMATION
inputs is programmed as Digital Counter, that counter measurement will appear here. The
counter can be reset to zero if the counter is of the incrementing type or pre-set to a
predetermined value using the
settings.

PATH: ACTUAL VALUES
[] MOTOR RUNNING
HOURS: 0 hr
TIME BETWEEN STARTS
MESSAGE
TIMER: 0 min
STARTS/HOUR TIMERS
MESSAGE
0 0
One of the 469 timers accumulates the total running time for the Motor. This may be useful
for scheduling routine maintenance. When this timer exceeds 100000, it will reset to 0. This
timer can be cleared using the
settings.
INFORMATION
The
TIME BETWEEN STARTS TIMER
planning a motor shutdown. The
RESET MOTOR INFORMATION
settings. If one of the assignable digital

S1 469 SETUP CLEAR DATA

A4 MAINTENANCE TIMERS
0 0 0 min

S1 469 SETUP INSTALLATION
value may be viewed here. This value might be useful for
STARTS/HOUR TIMER
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES
settings. Another of the 469

S1 469 SETUP

PRESET DIGITAL COUNTER
Range: 0 to 100000 hrs.
Range: 0 to 500 min.
Range: 0 to 60 min.

RESET MOTOR
value is also viewable here.
S1 469