GE 469 Instruction Manual page 179

CHAPTER 5: SETTINGS
 ASSIGNABLE []
INPUT 1
 ASSIGNABLE []
 ASSIGNABLE []
INPUT 1
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
Setting the
INPUT 1(4) FUNCTION
command via a switch input. The captured waveforms can be displayed with the relay
software. There are no additional settings associated with this value.
Simulate Pre-Fault

PATH: SETTINGS S3 DIGITAL INPUTS
Setting the
INPUT 1(4) FUNCTION
Simulate Pre-Fault mode as per the
setting via a switch input. This is typically used for relay or system testing. There are
MODE
no additional Digital Input settings associated with this value.
Simulate Fault

PATH: SETTINGS S3 DIGITAL INPUTS
INPUT 1
Setting the
INPUT 1(4) FUNCTION
Fault mode as per the
a switch input. This is typically used for relay or system testing. There are no additional
Digital Input settings associated with this value.
Simulate Pre-Fault ...Fault

PATH: SETTINGS S3 DIGITAL INPUTS
Setting the
INPUT 1(4) FUNCTION
Simulate Pre-Fault to Fault mode as per the
setting via a switch input. This is typically used for relay or system
SIMULATION MODE
testing. There are no additional Digital Input settings associated with this value.
to "Capture Trace" allows for trace capture upon

ASSIGNABLE INPUT 1(4)
INPUT 1 FUNCTION:
Simulate Pre-Fault
to "Simulate Pre-Fault" allows the user to start the
S13 469 TESTING

ASSIGNABLE INPUT 1(4)
INPUT 1 FUNCTION:
Simulate Fault
to "Simulate Fault" allows the user to start the Simulate

S13 469 TESTING SIMULATION MODE

ASSIGNABLE INPUT 1(4)
INPUT 1 FUNCTION:
Sim Pre-Fault.Fault
to "Sim Pre-Fault.Fault" allows the user to start the
S13 469 TESTING
Range: See above.
 
SIMULATION MODE SIMULATION
Range: See above.

SIMULATION MODE
Range: See above.

SIMULATION MODE
setting via

5–35