S1 469 Setup - GE 469 Instruction Manual

5.2

S1 469 Setup

5.2.1 Passcode

PASSCODE
5–8

PATH: SETTINGS S1 469 SETUP
[] ENTER PASSCODE FOR
ACCESS:
SETPOINT ACCESS:
MESSAGE
Permitted
CHANGE PASSWORD:
MESSAGE
No
A passcode access security feature is provided in addition to the settings access jumper.
When shipped from the factory, the passcode is '0'. Settings write access is permitted
when the passcode is 0. The settings access jumper is required for changing settings from
the front panel keypad.
The
ENTER PASSCODE FOR ACCESS
is "Restricted". The
SETPOINT ACCESS
seen only if the passcode is 0 and the
To enable passcode protection on a new relay, follow the procedure below:
1. Press MESSAGE  then MESSAGE  until
2. Select "Yes" and follow the directions to enter a new passcode 1 to 8 digits in
length.
3. Once a passcode (other than "0") is programmed, it must be entered each time
settings access is restricted. If a non-zero passcode has been programmed and
settings access is restricted, then the
appears when entering the
4. Enter the correct passcode. A flash message will advise if the code is incorrect
and allows a retry. If the passcode is correct and the settings access jumper is
installed, the
SETPOINT ACCESS: Permitted
5. settings can now be entered. Press ESCAPE to exit the
group and program the appropriate settings. If no keys are pressed for 5 min-
utes, programming access will no longer be allowed and the passcode must be
re-entered. Removing the settings access jumper or setting the
settings to "Restricted" will also immediately disable settings access.
ACCESS
If a new passcode is required, gain settings access by entering the valid passcode as
described above, then press
and follow directions. If an invalid passcode is entered, an encrypted passcode may be
viewed by pressing the
HELP
if the currently programmed passcode is unknown. Using a deciphering program, the
passcode can be determined.

PASSCODE
settings is seen only if the passcode is not 0 and
and
SETPOINT ACCESS
SETPOINT ACCESS
CHANGE PASSCODE?
ENTER PASSCODE FOR ACCESS

S1 469 SETUP PASSCODE
message appears.
 to display the
MESSAGE
key. Consult the factory service department with this number
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
Range: 1 to 8 numeric digits
Range: Permitted, Restricted
Range: No, Yes
settings are
CHANGE PASSWORD
is "Permitted".
is displayed.
message
subgroup.

S1 469 SETUP PASSCODE
SETPOINTS
message
CHANGE PASSCODE