F Lash M Essages - GE 469 Instruction Manual

6.8.2 Flash Messages
[.] KEY IS USED
TO
ADVANCE THE CUR-
SOR
ARE YOU SURE?
PRESS
[ENTER] TO VERIFY
DEFAULT MESSAGE
HAS BEEN ADDED
END OF LIST
INVALID PASSCODE
ENTERED!
NEW settings HAS
BEEN STORED
OUT OF RANGE!
ENTER:
####-##### by #
ROUNDED settings
HAS BEEN STORED
TIME ENTRY
OUT OF RANGE
6–38
START BLOCK
LOCKOUTS:
When the has been pressed, the hot RTD condition is no longer present, and the
RESET
lockout time has expired, the display will revert back to the normal Default Messages.
Flash messages are warning, error, or general information messages that are temporarily
displayed in response to certain key presses. These messages are intended to assist with
navigation of the 469 messages by explaining what has happened or by prompting the
user to perform certain actions.
ACCESS DENIED,
ENTER PASSCODE
DATA CLEARED
SUCCESSFULLY
DEFAULT MESSAGE
HAS BEEN REMOVED
END OF PAGE
INVALID SERVICE
CODE ENTERED
NO ALARMS
PRESS [ENTER] TO
ADD
DEFAULT MESSAGE
settings ACCESS
IS
NOW PERMITTED
TIME ENTRY WAS
NOT COMPLETE
• [.] KEY IS USED TO ADVANCE THE CURSOR: Any time a settings that requires text
editing is viewed, this message will appear immediately to prompt the user to use the
decimal key for cursor control. If the settings is not altered for one (1) minute, the
message will flash again.
• ACCESS DENIED, ENTER PASSCODE: The 469 has a passcode security feature. If that
feature has been enabled, not only do the access switch terminals have to be shorted,
but the passcode must also be entered. If the correct passcode has been lost or
OVERLOAD LOCKOUT
BLOCK: 25 min
ACCESS DENIED,
SHORT ACCESS
SWITCH
DATE ENTRY
OUT OF RANGE
DEFAULT MESSAGE
LIST IS FULL
ENTER NEW PASS-
CODE
FOR ACCESS
KEY PRESSED IS
INVALID HERE
NO START BLOCKS
ACTIVE
PRESS [ENTER] TO
REMOVE MESSAGE
settings ACCESS
IS
NOW RESTRICTED
TOP OF LIST
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES
ALL POSSIBLE
RESETS
HAVE BEEN PER-
FORMED
DATE ENTRY WAS
NOT COMPLETE
DEFAULT MESSAGES
6 TO 20 ARE
ASSIGNED
INPUT FUNCTION
ALREADY ASSIGNED
NEW PASSCODE
HAS BEEN ACCEPTED
NO TRIPS OR
ALARMS
TO RESET
RESET PERFORMED
SUCCESSFULLY
THIS FEATURE NOT
PROGRAMMED
TOP OF PAGE