Binding service instances with VPLS instances
Network requirements
CE 1 and CE 2 are connected to PE 1 and PE 2 through VLANs.
On PE 1 and PE 2, perform the following configuration:
•
Configure VPLS instance aaa to use LDP (Martini mode) and VPLS instance bbb to use BGP
(Kompella mode), and configure the AS number as 100.
Configure service instance 1000 to match packets that are received on GigabitEthernet 1/0/1 and
•
carry the VLAN tag of 100. Bind service instance 1000 to VPLS instance aaa.
Configure service instance 2000 to match packets that are received on GigabitEthernet 1/0/1 and
•
carry VLAN tag of 200. Bind service instance 2000 to VPLS instance bbb.
Figure 43 Network diagram
GE1/0/ 1
CE 1
Configuration procedure
Configure PE 1:
1.
# Configure an IP address for loopback 0.
<Sysname> system-view
[Sysname] sysname PE1
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
# Configure the LSR ID and enable MPLS globally.
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls
[PE1-mpls] quit
# Enable L2VPN and MPLS L2VPN.
[PE1] l2vpn
[PE1-l2vpn] mpls l2vpn
[PE1-l2vpn] quit
# Enable LDP globally.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure PE 1 to establish an LDP remote session with PE 2.
[PE1] mpls ldp remote-peer 1
[PE1-mpls-ldp-remote-1] remote-ip 3.3.3.9
Loop 0
1.1 .1. 9/ 24
Vlan-int 2
23. 1.1 .1/ 24
23 .1 .1. 2/ 24
PE 1
Loop 0
2.2 .2. 9/ 24
Vlan -int 2
Vlan-int 3
26. 2.2 .2/ 24
P
175
Loop
3 .3. 3. 9/ 24
Vlan -int 3
26. 2. 2. 1/24
GE1/0/1
PE 2
CE 2