Configuring Rsvp-Te Advanced Features; Configuring Rsvp Reservation Style - HP 10500 SERIES Configuration Manual

Establishing an MPLS TE tunnel with RSVP-TE
To use RSVP-TE to set up an MPLS TE tunnel, enable both MPLS TE and RSVP-TE on the interfaces for the
tunnel to use on each node along the tunnel.
To establish an MPLS TE tunnel with RSVP-TE:
Step
1. Enter system view.
2. Enter MPLS view.
3. Enable RSVP-TE for the switch.
4. Exit to system view.
5. Enter interface view of MPLS
TE link.
6. Enable RSVP-TE on the
interface.
7. Enter MPLS TE tunnel interface
view.
8. Set the signaling protocol for
setting up the MPLS TE tunnel
to RSVP-TE.
9. Submit current tunnel
configuration.

Configuring RSVP-TE advanced features

RSVP-TE adds new objects in Path and Resv messages to support CR-LSP setup. RSVP-TE provides many
configurable options with respect to reliability, network resources, and other advanced features of MPLS
TE.
Before performing the configuration tasks in this section, be aware of each configuration objective and
its impact on your network.
Before you configure RSVP-TE advanced features, complete the following tasks:
Configure basic MPLS.
•
Configure basic MPLS TE.
•
Establish an MPLS TE tunnel with RSVP-TE.
•

Configuring RSVP reservation style

Each LSP set up using RSVP-TE is assigned a resource reservation style. During an RSVP session, the
receiver decides which reservation style to use for this session and thus which LSPs to use.
Two reservation styles are available:
• FF style—Resources are reserved for individual senders and cannot be shared among senders on
the same session.
SE style—Resources are reserved for senders on the same session and shared among them.
•
Command
system-view
mpls
mpls rsvp-te
quit
interface interface-type
interface-number
mpls rsvp-te
interface tunnel tunnel-number
mpls te signal-protocol rsvp-te
mpls te commit
107
Remarks
N/A
N/A
Disabled by default.
N/A
N/A
Disabled by default.
N/A
Optional.
RSVP-TE applies by default.
N/A