HP 10500 SERIES Configuration Manual page 165

[PE2-Vlan-interface2] mpls
[PE2-Vlan-interface2] mpls te
[PE2-Vlan-interface2] mpls rsvp-te
[PE2-Vlan-interface2] quit
Enable OSPF TE:
3.
# Configure PE 1.
[PE1] ospf
[PE1-ospf-1] opaque-capability enable
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] mpls-te enable
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# Configure PE 2.
[PE2] ospf
[PE2-ospf-1] opaque-capability enable
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] mpls-te enable
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
Configure an MPLS TE tunnel:
4.
# Create a TE tunnel with PE 1 as the ingress node and PE 2 as the egress node. The signaling
protocol is RSVP-TE.
[PE1] interface tunnel 1
[PE1-Tunnel1] ip address 12.1.1.1 255.255.255.0
[PE1-Tunnel1] tunnel-protocol mpls te
[PE1-Tunnel1] destination 3.3.3.3
[PE1-Tunnel1] mpls te tunnel-id 10
[PE1-Tunnel1] mpls te signal-protocol rsvp-te
[PE1-Tunnel1] mpls te commit
[PE1-Tunnel1] quit
# Execute the display interface tunnel command on PE 1. You can see that the tunnel interface is
up.
Configure the VPN instance on each PE, and bind it to the interface connected to the CE:
5.
# Configure on CE 1.
<CE1> system-view
[CE1] interface vlan-interface 1
[CE1-Vlan-interface1] ip address 192.168.1.2 255.255.255.0
[CE1-Vlan-interface1] quit
# Configure the VPN instance on PE 1, and use CR-LSP for VPN setup. Bind the VPN instance with
the interface connected to CE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 100:1 both
[PE1-vpn-instance-vpn1] tnl-policy policy1
[PE1-vpn-instance-vpn1] quit
[PE1] tunnel-policy policy1
[PE1-tunnel-policy-policy1] tunnel select-seq cr-lsp load-balance-number 1
157