HP 10500 SERIES Configuration Manual page 156

[SwitchA-Tunnel4] ip address 10.1.1.1 255.255.255.0
[SwitchA-Tunnel4] tunnel-protocol mpls te
[SwitchA-Tunnel4] destination 4.4.4.4
[SwitchA-Tunnel4] mpls te tunnel-id 10
[SwitchA-Tunnel4] mpls te path explicit-path pri-path preference 1
# Enable FRR.
[SwitchA-Tunnel4] mpls te fast-reroute
[SwitchA-Tunnel4] mpls te commit
[SwitchA-Tunnel4] quit
# Execute the display interface tunnel command on Switch A.
[SwitchA] display interface tunnel
Tunnel4 current state: UP
Line protocol current state: UP
Description: Tunnel4 Interface
The Maximum Transmit Unit is 64000
Internet Address is 10.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.4
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
The output shows that Tunnel4 is up.
# Execute the display mpls te tunnel-interface command on Switch A to verify the configuration of
the tunnel interface.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc
Tunnel Attributes
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel4
: Tunnel4 Interface
: CR-LSP is Up
:
: 1.1.1.1:1
: 10
: UP
: 1.1.1.1
: RSVP
: CT0
: 0 kbps
: 7
: 0/0
: pri-path
None
: None
148
0/100/0
0/500/0
0/75/0
Oper State : UP
Egress LSR ID: 4.4.4.4
Resv Style : SE
Tunnel BW : 0 kbps
Hold Priority: 7