HP 10500 SERIES Configuration Manual page 160

# Execute the display mpls te tunnel-interface command on Switch A to view the configuration of
the tunnel interface.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc
Tunnel Attributes
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
Tunnel Name
Tunnel Desc
Tunnel State Desc
Tunnel Attributes
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
: Tunnel4
: Tunnel4 Interface
: Modifying CR-LSP is setting up
:
: 1.1.1.1:1
: 10
: UP
: 1.1.1.1
: RSVP
: CT0
: 0 kbps
: 7
: 0x0/0x0
: pri-path
None
: None
: Enabled Record Label :
: Enabled BackUpBW Flag:
: - BackUpBW
: Disabled
: 10
: Disabled
: None
: -
: Disabled
: -
-
-
: NONE
: -
: Disabled
: Primary
: -
: -
: -
: Tunnel4
: Tunnel4 Interface
: Modifying CR-LSP is setting up
:
: 1.1.1.1:1025
: 10
:
: 1.1.1.1
: RSVP
152
Oper State : UP
Egress LSR ID: 4.4.4.4
Resv Style : SE
Tunnel BW : 0 kbps
Hold Priority: 7
Enabled
Not Supported
: -
Retry Interval:
Reopt Freq :
Auto BW Freq :
Max BW
Oper State : Modified
Egress LSR ID: 4.4.4.4
Resv Style : SE
10 sec
-
-
: -