Configuring Svc Mpls L2Vpn - HP 10500 SERIES Configuration Manual

Intf
In-label
Out-label
Nexthop
The output shows that a remote CCC connection has been established.
# Ping CE 2 from CE 1.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=180 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=10 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=70 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=60 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 10/76/180 ms
The output shows that CE 1 and CE 2 can ping each other.

Configuring SVC MPLS L2VPN

Network requirements
CEs are connected to PEs through VLAN interfaces.
Establish an SVC MPLS L2VPN between CE 1 and CE 2.
Figure 9 Network diagram
Vlan-int10
Vlan-int10
CE 1
Device
CE 1
PE 1
PE 2
Configuration considerations
Configure basic MPLS settings on the PEs and P device.
1.
data bytes, press CTRL_C to break
PE 1 P
Loop0 Loop0
Vlan-int20
Vlan-int20
SVC
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int20 10.1.1.1/24
Loop0 192.3.3.3/32
Vlan-int30 10.2.2.1/24
: Vlan-interface10 (up)
: 100
: 200
: 10.1.1.2
PE 2
Loop0
Vlan-int30
Vlan-int30
Vlan-int10
Vlan-int10
Device
CE 2
P
212
CE 2
Interface IP address
Vlan-int10 100.1.1.2/24
Loop0 192.4.4.4/32
Vlan-int30 10.2.2.2/24
Vlan-int20 10.1.1.2/24