Enabling Mpls Trap; Displaying And Maintaining Mpls; Displaying Mpls Operation - HP 10500 SERIES Configuration Manual

Step
1. Enter system view.
2. Enable LSP verification and
enter the MPLS LSPV view.
3. Configure periodic tracert for
an LSP to the specified FEC
destination.

Enabling MPLS trap

With the MPLS trap function enabled, trap packets of the notifications level are generated to report
critical MPLS events. Such trap packets are sent to the information center of the device. Whether and
where the packets are output depend on the configurations of the information center. For information on
how to configure the information center, see Network Management and Monitoring Configuration
Guide.
To enable the MPLS trap function:
Step
1. Enter system view.
2. Enable the MPLS trap.

Displaying and maintaining MPLS

Use the commands in this section to verify MPLS configuration and maintain MPLS statistics.

Displaying MPLS operation

Task
Display information about one or
all MPLS-enabled interfaces.
Display information about ILM
entries. (In standalone mode.)
Command
system-view
mpls lspv
periodic-tracert
destination-address mask-length
[ -a source-ip | -exp exp-value | -h
ttl-value | -m wait-time | -t time-out
| -u retry-attempt ] *
Command
system-view
snmp-agent trap enable mpls
Command
display mpls interface
[ interface-type interface-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
display mpls ilm [ label ]
[ verbose ] [ slot slot-number ] [ |
{ begin | exclude | include }
regular-expression ]
78
Remarks
N/A
Not enabled by default.
Not configured by default.
Remarks
N/A
By default, the MPLS trap is
disabled.
For more information about the
command, see the snmp-agent
trap enable command in Network
Management and Monitoring
Command Reference.
Remarks
Available in any view.
Available in any view.