HP 10500 SERIES Configuration Manual page 291

[P-Vlan-interface13] quit
[P] interface vlan-interface 12
[P-Vlan-interface12] mpls
[P-Vlan0interface12] mpls ldp
[P-Vlan-interface12] quit
# Configure PE 2.
[PE2] mpls lsr-id 3.3.3.9
[PE2] mpls
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface vlan-interface 12
[PE2-Vlan-interface12] mpls
[PE2-Vlan-interface12] mpls ldp
[PE2-Vlan-interface12] quit
After the configurations, P establishes an LDP session with PE 1 and PE 2, respectively. Issue the
display mpls ldp session command. The output shows that the session status is Operational. Issue
the display mpls ldp lsp command. The output shows the LSPs established by LDP. Take PE 1 as an
example:
[PE1] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
---------------------------------------------------------------
2.2.2.9:0
---------------------------------------------------------------
LAM : Label Advertisement Mode
[PE1] display mpls ldp lsp
------------------------------------------------------------------
SN DestAddress/Mask
------------------------------------------------------------------
1 1.1.1.9/32
2 2.2.2.9/32
3 3.3.3.9/32
------------------------------------------------------------------
A '*' before an LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale
Configure VPN instances on PEs:
3.
# Configure PE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 111:1
[PE1-vpn-instance-vpn1] quit
[PE1] ip vpn-instance vpn2
[PE1-vpn-instance-vpn2] route-distinguisher 100:2
[PE1-vpn-instance-vpn2] vpn-target 222:2
LDP Session(s) in Public Network
Status LAM
Operational DU
LDP LSP Information
In/OutLabel
3/NULL
NULL/3
NULL/1024
283
SsnRole FT MD5
Passive Off Off
FT : Fault Tolerance
Next-Hop In/Out-Interface
127.0.0.1 -------/InLoop0
172.1.1.2 -------/Vlan-interface13
172.1.1.2 -------/Vlan-interface13
KA-Sent/Rcv
5/5