Creating And Configuring Mpls L2Vpn; Creating A Ce Connection - HP 10500 SERIES Configuration Manual

Step
6. Enable the filtering by the
VPN
community attributes for the
received routing information.
7. Enable the specified peer or
peers
routing information of the
BGP-L2VPN address family.

Creating and configuring MPLS L2VPN

Step
1. Enter system view.
2. Create an MPLS L2VPN and
enter MPLS L2VPN view.
3. Configure an RD for the
L2VPN.
4. Associate the L2VPN with one
or more VPN targets.
5. Set the MTU for the L2VPN.

Creating a CE connection

Configuration parameters and guidelines
id ce-id: Specifies the CE ID of a local CE connected to the PE.
•
range ce-range: Specifies the CE range—the maximum number of CEs to which the specified CE
•
can connect.
You can configure a CE range greater than what is required based on your estimate of future VPN
expansion. This can reduce configuration workload required when CEs are added into the VPN in
future.
Command
target extended
policy vpn-target
to exchange BGP
peer { group-name | ip-address }
enable
Command
system-view
mpls l2vpn vpn-name [ encapsulation
{ ethernet | vlan } [ control-word |
no-control-word ] ]
route-distinguisher route-distinguisher
vpn-target vpn-target&<1-16> [ both |
export-extcommunity |
import-extcommunity ]
mtu mtu
205
Remarks
Optional.
Enabled by default.
N/A
Remarks
N/A
You must create an L2VPN
name on the PE for each VPN
where a directly connected
CE resides, and specify an
encapsulation type matching
the AC link type.
Once configured, an RD
cannot be changed, unless
you delete the L2VPN and
then recreate it.
N/A
Optional.
The default MTU is 1500.
The mtu command affects
only parameter negotiation. It
does not affect data
forwarding. HP does not
recommend using this
command