HP 10500 SERIES Configuration Manual page 195

[SwitchA-vlan100] port gigabitethernet 1/0/1
[SwitchA-vlan100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] l2 binding vsi vpna
[SwitchA-Vlan-interface100] return
# Configure Switch B.
[SwitchB] l2vpn
[SwitchB-l2vpn] mpls l2vpn
[SwitchB-l2vpn] quit
[SwitchB] vsi vpna static
[SwitchB-vsi-vpna] pwsignal ldp
[SwitchB-vsi-vpna-ldp] vsi-id 100
[SwitchB-vsi-vpna-ldp] peer 1.1.1.9 upe
[SwitchB-vsi-vpna-ldp] quit
[SwitchB-vsi-vpna] quit
# Configure Switch C.
[SwitchC] l2vpn
[SwitchC-l2vpn] mpls l2vpn
[SwitchC-l2vpn] quit
[SwitchC] vsi vpna static
[SwitchC-vsi-vpna] pwsignal ldp
[SwitchC-vsi-vpna-ldp] vsi-id 100
[SwitchC-vsi-vpna-ldp] peer 1.1.1.9 upe
[SwitchC-vsi-vpna-ldp] quit
[SwitchC-vsi-vpna] quit
Verify the configuration:
5.
# Use the display bfd session verbose command to display information about the BFD sessions
from Switch A to its neighbors.
<SwitchA> display bfd session verbose
Total Session Num: 2
Session Working Under Ctrl Mode:
Local Discr: 21
Source IP: 1.1.1.9
Session State: Up
Min Trans Inter: 400ms
Min Recv Inter: 400ms
Running Up for: 00:00:01
Connect Type: Indirect
Protocol: MFW/LDP
Diag Info: No Diagnostic
Local Discr: 4
Source IP: 1.1.1.9
Session State: Up
Min Trans Inter: 400ms
Init Mode: Active
Remote Discr: 20
Destination IP: 2.2.2.9
Interface: LoopBack0
Act Trans Inter: 400ms
Act Detect Inter: 2000ms
Auth mode: None
Board Num: 6
Remote Discr: 0
Destination IP: 3.3.3.9
Interface: LoopBack0
Act Trans Inter: 1000ms
187