HP 10500 SERIES Configuration Manual page 139

0 output error
# Execute the display mpls te tunnel command on each switch to view information about the MPLS
TE tunnel.
[SwitchA] display mpls te tunnel
LSP-Id
1.1.1.1:1
[SwitchB] display mpls te tunnel
LSP-Id
-
[SwitchC] display mpls te tunnel
LSP-Id
-
# Execute the display mpls lsp command or the display mpls static-cr-lsp command on each switch
to view information about the static CR-LSP.
[SwitchA] display mpls lsp
-------------------------------------------------------------------
-------------------------------------------------------------------
FEC
3.3.3.3/32
[SwitchB] display mpls lsp
------------------------------------------------------------------
------------------------------------------------------------------
FEC
-/-
[SwitchC] display mpls lsp
------------------------------------------------------------------
------------------------------------------------------------------
FEC
-/-
[SwitchA] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC
Tunnel0 3.3.3.3/32
[SwitchB] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC
Tunnel0 -/-
[SwitchC] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC
Tunnel0 -/-
On an MPLS TE tunnel configured using a static CR-LSP, traffic is forwarded directly based on label
at the transit nodes and egress node. Therefore, it is normal that the FEC field in the sample output
is empty on Switch B and Switch C.
Direct traffic to the MPLS TE tunnel:
7.
Destination In/Out-If
3.3.3.3 -/Vlan1
Destination In/Out-If
- Vlan1/Vlan2
Destination In/Out-If
- Vlan2/-
LSP Information: STATIC CRLSP
In/Out Label In/Out IF
NULL/20 -/Vlan1
LSP Information: STATIC CRLSP
In/Out Label In/Out IF
20/30 Vlan1/Vlan2
LSP Information: STATIC CRLSP
In/Out Label In/Out IF
30/NULL Vlan1/-
I/O Label
NULL/20
I/O Label
20/30
I/O Label
30/NULL
131
Name
Tunnel0
Name
Tunnel0
Name
Tunnel0
Vrf Name
Vrf Name
Vrf Name
I/O If
-/Vlan1
I/O If
Vlan1/Vlan2
I/O If
Vlan2/-
State
Up
State
Up
State
Up