HP 10500 SERIES Configuration Manual page 260

To configure a tunneling policy for a VPN instance:
Step
1. Enter system view.
2. Create a tunneling
policy and enter
tunneling policy view.
3. Configure a preferred
tunnel and specify a
tunnel interface for it.
4. Specify the tunnel
selection preference
order and the number
of tunnels for load
balancing.
5. Return to system view.
6. Enter VPN instance
view.
7. Enter IPv4 VPN view.
8. Apply the tunnel policy
to the VPN instance.
NOTE:
A tunneling policy configured in VPN instance view is applicable to both IPv4 VPNs and IPv6 VPNs.
•
You can configure a tunneling policy for IPv4 VPNs in both VPN instance view and IPv4 VPN view. A
•
tunneling policy configured in IPv4 VPN view takes precedence.
Command
system-view
tunnel-policy tunnel-policy-name
preferred-path number interface
tunnel tunnel-number
[ disable-fallback ]
tunnel select-seq { cr-lsp | lsp } *
load-balance-number number
quit
ip vpn-instance
vpn-instance-name
ipv4-family
tnl-policy tunnel-policy-name
252
Remarks
N/A
N/A
Optional.
By default, no preferred tunnel is
configured.
In a tunneling policy, you can configure up
to 64 preferred tunnels.
The tunnel interfaces specified for the
preferred tunnels can have the same
destination address and the tunnel
encapsulation type must be MPLS TE.
Optional.
By default, only one tunnel is selected (no
load balancing) in this order: LSP tunnel,
CR-LSP tunnel.
NOTE:
•
A tunnel type closer to the select-seq
keyword has a higher priority. For
example, with the tunnel select-seq lsp
cr-lsp load-balance-number 1
command configured, VPN uses a
CR-LSP tunnel only when no LSP exists.
After an LSP is created, the VPN uses
the LSP tunnel instead.
•
If you specify more than one tunnel type
and the number of tunnels of a type is
less than the specified number of
tunnels for load balancing, tunnels of
different types may be used.
N/A
N/A
Optional.
By default, only one tunnel is selected (no
load balancing) in this order: LSP tunnel,
CR-LSP tunnel.