HP 10500 SERIES Configuration Manual page 38

For VPN 1, advertise interface addresses on the two MCEs in area 0, making the entire VPN a single
OSPF domain. For VPN 2, advertise interface addresses for RIP and OSPF calculations, and in addition,
redistribute OSPF routes to RIP and RIP routes to OSPF on MCE 1.
Figure 9 Network topology of VPN 1 with the MCEs
Figure 10 Network topology of VPN 2 with the MCEs
Configuration procedure
Configure tunnels:
1.
Configure MCE 1:
•
# Create VLAN 100 and VLAN 101, configure GigabitEthernet 1/0/15 as a trunk port, and add
it to the two VLANs.
<MCE1> system-view
[MCE1] vlan 100 to 101
[MCE1] interface GigabitEthernet 1/0/15
[MCE1-GigabitEthernet1/0/15] port link-type trunk
[MCE1-GigabitEthernet1/0/15] port trunk permit vlan 100 101
[MCE1-GigabitEthernet1/0/15] quit
# Create VLAN interfaces, and configure IP addresses for them.
[MCE1] interface vlan-interface 100
[MCE1-Vlan-interface100] ip address 192.168.1.1 255.255.255.0
[MCE1-Vlan-interface100] quit
[MCE1] interface vlan-interface 101
[MCE1-Vlan-interface101] ip address 192.168.2.1 255.255.255.0
[MCE1-Vlan-interface101] quit
# Create tunnel interface Tunnel0.
[MCE1] interface tunnel 0
# Configure an IP address for the tunnel interface Tunnel0.
[MCE1-Tunnel0] ip address 10.1.1.1 255.255.255.0
# Specify the tunnel protocol as GRE.
30